Coda C3 Guide de l'utilisateur télécharger pdf (Page 10)

Using unbalanced connections

When connecting the C3 amplifier to an unbalanced audio source, the signal conductor

should be terminated to XLR pin2 and the cable screen terminated to both pins 1 and 3.

2 1

Pin 2 HOT +

Pin 1 Shield

Input XLR unbalanced connection

In bridged mode output channel 1 signal chain provides the signal for the 1 & 2 pair of

amplifier channels, output channel 3 signal chain provides the signal for the 3 & 4 pair.

Amplifier output connections

The C3 amplifier is fitted with one Speakon

connector per amplifier channel. The

appropriate conductor terminations are shown below and on the rear panel of the unit.

Amplifier output connections

The Speakon

connector for amplifier channel 1 carries the output for amplifier channels

1 and 2. In addition this connector can also be used if the pair of amplifier channels is

being operated in bridged mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Pas de commentaire

Coda C3 Guide de l'utilisateur Page 10